Fulltext

Experimental investigation of axial dispersion in a horizontal rotating cylinder

McLaren, C. ; Third, J. ; Müller, C.

In: Granular Matter, 2015, vol. 17, no. 1, p. 43-48

Ajouter à la liste personnelle
    Titre
    • Experimental investigation of axial dispersion in a horizontal rotating cylinder
    Auteur
    • McLaren, C.. Department of Mechanical and Process Engineering, Institute of Energy Technology, ETH Zürich, Leonhardstrasse 21, 8092, Zurich, Switzerland
    • Third, J.. Department of Mechanical and Process Engineering, Institute of Energy Technology, ETH Zürich, Leonhardstrasse 21, 8092, Zurich, Switzerland
    • Müller, C.. Department of Mechanical and Process Engineering, Institute of Energy Technology, ETH Zürich, Leonhardstrasse 21, 8092, Zurich, Switzerland
    Type de document
    • Postprint
    Identifiant OAI-PMH
    • oai:doc.rero.ch:332407
    Summary
    This work reports experimental measurements of the dispersion of particles during rotation in a horizontal cylinder. The axial dispersion of a pulse of approximately monodisperse black glass ballotini into a bed of clear glass ballotini of the same size is analysed. This is done using a sectioning technique, where the concentration is determined throughout the cylinder for a given rotation time and speed. The concentration profile is fitted to an appropriate solution of Fick's second law to determine the dispersion coefficient. The dispersion coefficient is compared for various drum rotation rates and glass ballotini sizes. The cylinder was filled to 35% by volume and rotated at a range of speeds between 5 and 20 rpm. The particle sizes vary from 1.14 to 3.15mm. The dispersion coefficient was found to be dependent on both particle size and rotation speed. As the rotation speed, $$\omega $$ ω , was increased the dispersion coefficient increased proportionally to $$\omega ^{0.8}$$ ω 0.8 . As the particle diameter, $$d_p$$ d p , was increased the dispersion coefficient increased proportionally to $$d_p^{1.84}$$ d p 1.84 . These results are compared with previous experimental and simulation data, in particular the simulations of Third et al. (Powder Technol 203:510, 2010). Strong agreement was found between the simulations of Third et al. and the experimental results.