In: Nanomedicine, 2018, vol. 13, no. 10, p. 1169–1185
Aim: The distribution and impact of aerosol-delivered gold nanoparticles (AuNPs) functionalized with a mixture of aminated-polyvinyl alcohol and amino-PEG ([polyvinyl alcohol/PEG]-NH2) upon repeated administration onto a 3D lung model were explored. Materials & methods: AuNPs were aerosolized and uptake and epithelial translocation was assessed by inductively coupled plasma optical-emission ...
|
In: Archives of Toxicology, 2018, vol. 92, no. 7, p. 2339–2351
Wear particles from automotive friction brake pads of various sizes, morphology, and chemical composition are significant contributors towards particulate matter. Knowledge concerning the potential adverse effects following inhalation exposure to brake wear debris is limited. Our aim was, therefore, to generate brake wear particles released from commercial low-metallic and non-asbestos organic...
|
In: Scientific Reports, 2018, vol. 8, no. 1, p. 9861
Three dimensional (3D) co-cultures to mimic cellular dynamics have brought significant impacts in tissue engineering approaches for biomedical research. Herein, we present a novel sample holder combined with time-lapse fluorescence imaging technique, referred as 4D live cell imaging, allowing direct visualization of various cells up to 24 hours. We further extended our approach to monitor...
|
In: Colloid and Interface Science Communications, 2018, vol. 22, p. 29–33
Taylor dispersion analysis (TDA) is an analytical method that has so far mainly been utilized to determine the diffusion coefficient of small molecules, and proteins. Due to increasing interest in nanoscience, some research has been done on the applicability of TDA towards characterizing nanoparticles. This work aims to expand this knowledge and give insight into the range for which TDA can...
|
In: Soft Matter, 2018, vol. 14, no. 19, p. 3998–4006
We perform a comparative study of dynamic force measurements using an Atomic Force Microscope (AFM) on the same soft polymer blend samples in both air and liquid environments. Our quantitative analysis starts with calibration of the same cantilever in both environments. Intermodulation AFM (ImAFM) is used to measure dynamic force quadratures on the same sample. We validate the accuracy of the...
|
In: Analytical Chemistry, 2018, vol. 90, no. 6, p. 3656–3660
Users of dynamic light scattering (DLS) are challenged when a sample of nanoparticles (NPs) contains dust. This is a frequently inevitable scenario and a major problem that critically affects the reproducibility and accuracy of DLS measurements. Current methods approach this problem via photon correlation spectroscopy, but remedy exists only for a few special cases. We introduce here a...
|
In: Environmental Pollution, 2018, vol. 235, p. 263–271
Adverse effect studies of gasoline exhaust are scarce, even though gasoline direct injection (GDI) vehicles can emit a high number of particles. The aim of this study was to conduct an in vitro hazard assessment of different GDI exhausts using two different cell culture models mimicking the human airway. In addition to gasoline particle filters (GPF), the effects of two lubrication oils with...
|
In: Advanced Materials, 2018, p. -
Realization of the immense potential of nanomaterials for biomedical applications will require a thorough understanding of how they interact with cells, tissues, and organs. There is evidence that, depending on their physicochemical properties and subsequent interactions, nanomaterials are indeed taken up by cells. However, the subsequent release and/or intracellular degradation of the...
|
In: Advanced Materials, 2018, p. -
Progress in the field of nanoparticles has enabled the rapid development of multiple products and technologies; however, some nanoparticles can pose both a threat to the environment and human health. To enable their safe implementation, a comprehensive knowledge of nanoparticles and their biological interactions is needed. In vitro and in vivo toxicity tests have been considered the gold...
|
In: The Journal of Physical Chemistry C, 2017, vol. 121, no. 48, p. 27164–27175
Magnetic nanoparticles and their ability to convert electromagnetic energy into heat are of explicit interest for various applications. However, precise quantification of their heating efficiency is not always upfront, and several parameters render comparative studies challenging. This paper describes the theory behind lock-in thermography, a new technique for quantifying the heating...
|