Faculté des sciences de base SB, Section de chimie et génie chimique, Institut des sciences et ingénierie chimiques ISIC (Laboratoire de génie de la réaction chimique LGRC)

Study of N2O decomposition over Fe-ZSM-5 with transient methods

Prechtl, Petra ; Kiwi, Lioubov (Dir.) ; Renken, Albert (Dir.)

Thèse Ecole polytechnique fédérale de Lausanne EPFL : 2007 ; no 3884.

Ajouter à la liste personnelle
    Nitrous oxide is the third most important gas contributing to global warming and its concentration in the atmosphere is still on the rise. Nitric acid production represents the largest source of N2O in the chemical industry, with a total annual emission of about 400 kt N2O. An efficient way to reduce the N2O is the catalytic decomposition into N2 and O2. ZSM-5 zeolites containing iron are known to be effective in this reaction involving Fe(II)-extraframework species as active sites. But the nature of these sites and the reaction network is still under debate. Often the N2O is in the exhaust together with other gases like NOx, COx, oxygen, and water vapor, which may influence the catalyst efficiency towards N2O decomposition. The effect of these gases on the reaction mechanism is still not understood yet. The aim of this work is to study the decomposition mechanism of N2O over isomorphously substituted Fe-ZSM-5 (0.02-0.55% Fe) using transient response methods. Kinetic studies under steady-state conditions give overall information about the reaction, whereas transient experiments lead to information on the individual steps and the possibility to suggest a reaction model. Transient response methods are applied in vacuum using a Temporal Analysis of Products (TAP) setup and at ambient pressure using a Micromeritics AutoChem 2910 analyzer. The influence of different gases such as NO, H2O and NO2 on the decomposition of N2O over Fe-ZSM-5 is investigated to gain insight into their effect on this reaction. The TAP multifunctional reactor system is used to perform transient pulse experiments for micro-kinetic analysis of complex heterogeneous catalytic reactions. This setup allows to dose precisely reactants and to monitor product formation with submillisecond time resolution implying the absence of external mass or heat transfer. A reproducible low hydroxylation level of the catalyst can be attained in vacuum. The results from the transient responses with the Micromeritics analyzer are obtained under conditions more relevant to "operando". The mechanism of N2O decomposition over Fe containing ZSM-5 was studied by transient response methods at ambient pressure with the Micromeritics analyzer and under vacuum with the TAP setup. Both approaches showed that the mechanism strongly depends on the reaction temperature, but in all cases involves atomic oxygen loading from N2O with N2 evolution as the first reaction step. The surface oxygen, (O)Fe, formed from N2O possesses very high reactivity and oxidizes CO to CO2 already at 373 K. A complete saturation of the active sites can be reached by the catalyst exposure to N2O at low temperatures (T < 600 K in vacuum, T < 523 K at ambient pressure). Under these conditions oxygen is stored and does not desorb. On that basis, the concentration of sites active for the surface atomic oxygen loading from N2O is determined by pulse experiments using the TAP setup. The concentration of active sites is found to be the same as in a flow experiment with the Micromeritics analyzer. The mechanism of surface atomic oxygen recombination and desorption as O2 depends on the temperature. At temperatures higher than 773 K, the mechanism probably involves direct (O)Fe recombination. The investigation of the response profiles upon N2O pulses at 803 K evidences the O2 formation is the rate-determining step since the oxygen desorption is found to be slow compared to N2O and N2. Furthermore, a fit of the oxygen desorption curve corresponded to a first order dependence on the oxygen surface coverage. In the range of 523 to 773 K, the O2 formation is facilitated by NO, which is formed on the catalyst surface from N2O. The addition of NO to the gas phase confirmed the accelerating effect of NO on the oxygen desorption. NO and (O)Fe are adsorbed on adjacent, but different sites and are not competing for the same ones. Adsorbed NO accommodates oxygen from N2O forming higher oxidized nitrogen oxide species NO2/NO3 which decompose back to NOads and molecular oxygen. Thus, the recombination of surface oxygen loaded from N2O is accelerated by a NO/NOx redox cycle whereas adsorbed NOx acts as co-catalyst. Adsorbed NO is oxidized by N2O easily as shown also by temperature-programmed desorption (TPD) experiments. Therefore, the interaction of gaseous NO2 with Fe-ZSM-5 at 523 K in vacuum and at ambient pressure is investigated and demonstrates the formation of two different NOx surface species accompanied by the evolution of gaseous NO. These surface species block the sites for oxygen loading from N2O whereas the amount of reversible adsorbed N2O stays constant compared to the standard pre-treated catalyst. The formation of reactive surface oxygen from NO2 could neither be evidenced in TPD nor with CO oxidation experiments. Adsorbed water strongly influences the N2O decomposition inhibiting it completely, at least at temperatures ≤ 673 K. Water pulses at 523 and 593 K result in partial desorption of the loaded atomic surface oxygen as O2, indicating the competition of water for the same adsorption sites. The residual adsorbed oxygen desorbs during TPD experiments at 849 K instead of 715 K for the dry catalyst and it can not oxidize CO to CO2. It means that the active sites are transformed into an inactive form in the presence of water. The oxygen which stays on the catalyst seems to participate in the Fe(II) oxidation to the hydroxylated Fe(III) species. These Fe(III) species are inactive in N2O decomposition and could be activated again by high temperature treatment in He or in vacuum. During TAP experiments only small amounts of water are dosed and the water desorption is facilitated due to vacuum. Therefore, the effect of water could be shown to be reversible at temperatures > 700 K. At 803 K oxygen desorbs significantly faster with increasing water amount suggesting a water assisted O2 desorption. Simultaneously, the catalyst activity decreases to about a half of the initial activity of the dry zeolite. To conclude, from the TAP reactor data obtained under vacuum conditions and the results from the transient flow experiments at ambient pressure it follows that the mechanism of the N2O decomposition over Fe-containing ZSM-5 depends strongly on the reaction temperature and on the presence of NO, H2O and NO2. In general, below 523 K only surface atomic oxygen loading from N2O takes place with simultaneous evolution of N2 in the gas phase. The O2 formation proceeds via direct (O)Fe recombination at temperatures above 773 K. In the range of 523 to 773 K, the recombination of the atomic oxygen involves NOx adsorbed on the catalyst surface.